CHAPTER 6 – SERVICE
Once you have removed the screws, fold the Marquee back. See the following figure. You can now pull
forward on the monitor cover and remove it from the cabinet. Remove the 4 bolts holding the monitor to the
cabinet. Most of the weight of the monitor is located in the CRT at the front of the monitor. Carefully remove
the monitor and set it in a safe place. To re-install a monitor reverse this process. Always clean the front of the
CRT before re-installing the monitor bezel back in place.
Figure 51
– Removing the Monitor
Wells Monitor Chassis PCB Removal
You can uninstall the monitor chassis PCB if you should have problems with just the PCB. Only a certified
technician should perform the service steps to remove the PCA. GLOBAL VR assumes no responsibility for
damage while removing the PCB.
1. Begin by removing the (4x) nuts that holding the monitor chassis to the monitor frame. Next remove the
(2x) 4/40 Jack nuts that hold the video signal PCB to the monitor frame. See the figure below.
Figure 52
– Removing the Monitor PCB Mounting Hardware
Need For Speed™ GT
System Documentation
45
040-1201-01 Rev. C 5/28/2004
