CHAPTER 3 – UPGRADING AN OLDER CABINET
9. When the automatic reboot is complete, you will see a black screen with the Windows Start menu and
taskbar.
10. Open the CD drive and insert
Need For Speed Disk 1 of 2
. The installer will automatically start (wait
about 30 seconds). This install process will take approximately 10 minutes. You will see several different
windows appear while game files copy to the hard drive.
11. When the first CD is complete, the computer will eject the CD. The screen will tell you to insert CD Disk 2.
Remove CD Disk 1 of 2 and insert
Need For Speed CD Disk 2 of 2
.
12. The computer will copy the remaining files from Disk 2 and will reboot when finished.
13. After reboot is complete, the cabinet will check for a valid NFS game dongle. Then the game will prompt
you to perform a set of simple calibration tasks.
14. When the calibration is complete, the game attract mode will begin. Press the operator button behind the
coin door to enter the Operator Menus. You will need to set the Sound Volume, Attract Mode Volume, and
Cabinet ID# (for linked cabinets). You will have recorded these numbers in Step 2. You should play one
complete game to ensure correct operation.
15. Once the Cabinet ID# has been set, you can reconnect the Ethernet cable to the back of the cabinet. Note
that some cabinets may automatically reboot when linked. For more information about the linking process,
refer to the
Need for Speed Instruction Manual
.
16. After the install process is complete, you may remove CD Disk 2 of 2. Keep the CD set in a safe place in
case you need to reinstall the software.
You have now completed the software installation process for this cabinet. Repeat the process for any other
NFS cabinets you have.
Need For Speed™ GT
System Documentation
21
040-1201-01 Rev. C 5/28/2004
