9
INSTALLING THE EDGE TRIM
Suggested Sequence
The in
stallati
on of edging framework is a 3 step process
1.
Ensure all parts
fit
together well around the panel.
2.
In the recommended sequence (labeled above), one edge at a
ti
me, apply the liquid
adhesive to the panel edge using a caulking gun, and then adhere the edge pieces to the
panel edge.
3.
Repeat above step for the remaining 3 panel edges, in the recommended sequence.
1.
Ensure Proper Fit
A.
Lay the 7 rubber edge trim pieces around the perimeter of the PowerFLEX
TM
panel.
B.
Starti
ng at the end opposite the cables [labeled “1” above], carefully place the trim piece
so that the inner edge of edge trim piece is centered and bu
tt
ed against the edge of the
panel.
C.
Next, align and place the two trim pieces at the wiring end of the panel [labeled “2”
above] in the same manner, making sure the trim part
s fit
properly against the edge of
the panel.
D.
Place a long, side trim piece [labeled “3” and ”4” above] so that there is a 1/8” gap
between it and the end trim that has already been placed. Repeat for the remaining
pieces of side trim [labeled “5” and “6” above. A gap where the two side pieces meet in
the center is normal.
1
2
3
4
5
6
DOCUMENT NO. 1000564 REV. E
