User's Manual
Wall Mounted Water Bottle
Refilling Station
2
Risk of Electrical Shock
• Disconnect power before servicing unit.
• Electric supply must be identical in voltage, cycle and
phase to those specified in the specifications below.
Unit must be plugged into a GFCI outlet.
• Always pull the plug – not the cord – when disconnecting
from the outlet.
• DO NOT use if the power cord is worn or damaged.
Power cords should only be replaced by qualified
service technicians using genuine replacement parts.
• Check local codes for electrical requirements.
• DO NOT disassemble or modify unit.
• Use Global Industrial filters only – Model 670336
Note:
• Prior to installation, consult with local, state, and federal
codes for proper mounting height.
• All installation and service should only be performed by
authorized personnel.
• Dimensions shown below comply with ADA requirements
at time of printing.
• Allow 4" minimum clearance on both sides to allow for
proper ventilation through cabinet louvers.
• Thoroughly flush all water lines and fittings of all foreign
matter before connecting to the Cooling System.
Failure to do so will void warranty.
Required Tools:
1. Safety Glasses
2. Safety Gloves
3. Electric Drill
4. Phillips Head Screwdriver
5. Flathead Screwdriver
6. Tape Measure
7. Pencil
8. Level Device
9. (11) 75-lb. Capacity Flat Head Wall Anchors
(appropriate for your wall type)
10. (11) Flat Head Anchor Screws
WARNING
• Review manual thoroughly and verify rough-ins before
installation. Keep these instructions in a safe location
for future reference.
• Keep compressor in upright position for 24 hours
before water connections and initial power-on.
Failure
to do so will void warranty.
• It is recommended to assemble this product on a
tabletop or bench.
• Fixture must be mounted to a flat finished industry
standard wall surface. The wall surface must have
adequate support to secure the fixture, with the
addition of wall anchors (not included) if required.
• All receptacles must be wired to a GFCI protected
circuit. Fixture must be earth grounded per National
Electric Code (NEC).
• Inspect fixture and all parts for damage.
Package Contents:
Box 1 - 761319 Top Assembly for Bottle Filler
Box 2 - 761212 Cooling System for Water Fountain
Stainless
Steel Pan
Water
Filter
Not Pictured:
Hardware Bag
Mounting Stencil
Mounting Bracket
(attached to rear)
Cooling System
Rubber Gasket
Mounting Bracket
(attached to rear)
Bottle Filler
Top Assembly
Note: This product complies with ADA when installed
according to the requirements outlined in this manual.
Installation may require additional accessories to be fully
compliant. If needed, consult with the local Authority
Having Jurisdiction (AHJ).
Voltage/Hertz
115V/60Hz
*Chilling Capacity
5.3 GPH
Full-Load Amps
1.9 Amps
Rated Watts
185 W
Filter Capacity
4750 or 3600 Gallons
Quick-Fill Rate
1.0 GPM
Water Flow
Laminar
Certification
UL399 and CAN/CSA 22.2 No. 120 ADA
Compliant
Overall Dimensions
18
1/8
"W x 16"D x 37
13/16
"H
System 761219 Certified by IAPMO R
&
T against
NSF/ANSI/CAN372 for lead free compliance
Filter 670336 certified by NSF to NSF/ANSI 42
&
53
* At 46° - 54° (F) against ambient air temperature of 77° (F)
