Page
13
of
52
REAR PANEL LAYOUT
1. Ethernet Connector
The Ethernet connector is for remote control from a web browser on a computer
connected to the same network as the MPI005HD MKII. For more information on
using the web interface, go to
The Ethernet control circuit has been deliberately kept separate to the network
audio circuit (no 6).
2. Ant (Antenna) A
This SMA connector is attached internally to the mobile phone module. The
supplied antenna should be connected to this connector. For best results it is
advisable to place the 2 antennas as far apart as practical and in areas of good
cell phone reception.
3. Line Out
This male XLR audio connector carries balanced line level (0dBu) analogue
audio that the phone module is receiving.
Using the divert facility it is possible to route the incoming audio from the phone
to either this output XLR or the handset interface.
It is possible to adjust this analogue output level using the ‘Output Levels’ menu.
4. Line In
This female XLR audio connector carries balanced line level (0dBu) analogue
audio to the input of the phone.
Using the divert facility it is possible to route the audio to the phone from either
this input XLR or the handset interface.
1.
Ethernet
2. Ant A
3. Line
Out
4. Line
In
5. Ant B
6. Dante
Network
7.
Handset
8. DC Loops
9. Mains
