9
Installation
WARNING:
Mounting of the infrared heater and its connection to the electric mains should be carried out only by
qualified professionals according to the Electrical Installation Regulations and Power System Safety Standards and
comply with all national and local electrical codes.
This heater comes with a stainless steel adjustable angle mounting bracket. The adjustable angle enables the heater to be
installed on horizontal and inclined surfaces
1. Open the package and carefully remove the heater.
2. Remove the packing material from the end of heater
3. Refer to the images in the
Site Selection
section for proper installation. If installing on a wall or ceiling, select the heater
location by locating the stud or structural beams to ensure secure fastening of the heater. Ensure that all minimum
clearances are achieved.
4. Follow the appropriate installation instructions for the intended application.
Wall-mounted installation: page 10
Ceiling-mounted installation: page 11
Single heater tower installation: page 12
Twin heater tower installation: page 13
A
A
A
A
B C
C
C
D
D
C
B
B
B
A: Holes for wall-mounted installation
B: Holes for twin heaters tower kit installation
C: Holes for single heater tower kit installation
D: Holes for single or twin heaters ceiling installation
Figure 9
Quantity
DSH Heater
1
Mounting Bracket
1
Securing Hardware:
M6 x 16 Philips Bolt
Spring Washer
Wing nut
2
Remote Control
1
AAA Batteries
2
The DSH heater package contains the following components:
