K
IT
: P/N 938-02000-01
K
IT
I
NSTRUCTIONS
: P/N 063-09019-01
R
EVISION
:
C
D
ATE
:
8/28/08
P
AGE
:
5
2008
©
Copyright Glasair Aviation LLC, Arlington, Washington All rights reserved
F
IGURE
2: C
UTTING THE
V
ENTILATOR
O
PENING IN THE
A
IR
B
OX
K1000-3
Nutplates (4)
places
Next, as shown in Figure 2 cut a hole for the eyeball ventilator in
the square aft face of the box. Find the center of the face by
marking diagonal lines from the corners, and then use a
2 ¾”
hole
saw to cut a circle centered on that point.
Finally, fit the eyeball ventilator into the opening and align the
edges of the square ventilator mounting flange with the edges of
the air box. Mark the four corner hole locations and then drill them
through the air box with a
#10
bit.
Pass-drill #10
(4) places
Use temporary
screws or #10 clecos
to hold in position
