Glacier bay FSUZAS2721A1SA1, Инструкция по использованию и уходу

Страница: 11 / 30

10
1
2
11
8 9
9
18
Weight
here
Weight
here
20
20
19
19
Installing the weight
Making the water supply connections
Attaching the quick connector
to the receiving block
Flushing and checking for leaks
HOMEDEPOT.COM/GLACIERBAY
Undermount Installation (continued)
11
Install the weight clip (20) at the point of the hose marking
“weight here”.
Insert the weight (19) onto the clip (20) by sliding it down onto the
clip (20).
Push the quick connector (18) firmly upward and attach it to the
receiving block (9). Pull down moderately to ensure the connection has
been made.
Thread the nut (1) on the supply line onto the outlet of the water supply
valve (2) and tighten with a wrench. Do not overtighten.
Pull the hose assembly out of the spout and remove the spray
head by unscrewing it from the hose in a counterclockwise
direction. Be sure to hold the end of the hose down into the sink
and turn the faucet to the warm position where it mixes hot and
cold water.
Flush the water lines for one minute. This flushes away any
debris that could cause damage to internal parts Check for leaks.
Re-tighten any connections if necessary, but do not overtighten.
Reinstall the spray head by hand tightening it back onto the
spray hose in a clockwise direction.
IMPORTANT:
After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each other
and damaging.