ASSEMBLY INSTRUCTIONS
2. Install Wax Ring (CC), (Fig. 2)
Fig. 2
• Turn toilet bowl (B) upside down onto a towel or
cushioned surface. With the rounded (tapered) end
of the ring facing the toilet, place the wax ring
(CC) around the raised outlet ring of the bowl (B),
and press firmly enough so the wax ring (CC)
adheres to the bowl (B).
3. Position Toilet Bowl (B) on Toilet Flange, (Fig. 3)
Fig. 3
• Unplug waste opening in toilet flange. Gently
place toilet bowl (B) (right side up) in position
with the floor bolts (AA) protruding up through
the holes in the base of the toilet bowl (B). Level
toilet bowl (B) as it is lowered onto the toilet
flange.)
• Once toilet bowl (B) is in position, press down
with a slight twisting motion on the top center of
the bowl (B) eventually applying full body weight
to evenly compress the wax ring (CC) creating a
water-tight seal. (Do not rock the bowl
back-and-forth as this may break the seal.)
• Make sure the toilet bowl (B) is as level as
possible. It may be necessary to use small wedges
(shims) under the edge of the bowl due to slight
variations in vitreous chinaware or uneven floors.
(Toilet bowl (B) should be firmly seated on the
floor, so it does not wobble or rock.)
4. Secure Bowl to Floor, (Fig. 4)
Fig. 4
• Place plastic disc (DD) (Note: “THIS SIDE UP”),
metal washers (EE) and nuts (FF) on floor bolts
(AA). Alternately tighten nuts (FF) until toilet
bowl (B) is firmly seated on floor.
• DO NOT OVERTIGHTEN NUTS (FF)
BECAUSE VITREOUS CHINA CAN EASILY
CRACK OR CHIP.
• Pour water into toilet bowl (B) to prevent the
escape of sewer gases.
• Using a hacksaw, cut off excess length of floor
bolts (AA) so bolt caps (GG) will fit. (Leave no
more than 1/4-in length above nuts (FF)). Place
bolt caps (GG) over floor bolts (AA) and press
down for secure fit.
B
CC
B
AA
Toilet Flange
B
EE
DD
FF
AA
“THIS SIDE UP”
GG
AA
4
