114252-2-
BD
2001 Kohler Co.
PILLOW TALK
POWER LITE
VITREOUS CHINA TOILET
K-3379
1. BEFORE YOU BEGIN
A. HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes.
In addition to proper installation, read all operating
and safety instructions.
All information in this manual is based on the latest product
information available at the time of publication. Kohler Co.
reserves the right to make changes in product
characteristics, packaging, or availability at any time without
notice.
These instructions contain important care, cleaning, and
warranty information –
B. INSTALLER HAZARD NOTIFICATION
DANGER: Risk of electrical shock. Connect only
to a properly grounded, grounding-type receptacle,
protected by a Ground-Fault Circuit- Interrupter
(GFCI).
DANGER: Risk of injury or product damage.
Handle vitreous china products very carefully.
Vitreous china can break and chip if you overtighten
bolts and nuts.
NOTICE: Follow all local plumbing and
electrical codes.
C. PRODUCT PROPERTIES
One-piece vitreous china toilet.
Water depth from rim is 6-1/2” (16.5cm).
2-1/4” (5.7cm) passageway.
3’ (91.4cm) electrical cord length.
For roughing-in and overall dimensions, See
Fig. #3 .
Fixture dimensions are nominal and conform to
tolerances by ANSI/ASME standards
(A112.19.2M).
D. PRODUCT REQUIREMENTS
Toilet should be installed with a 3/8” shut-off valve.
Since all toilets do not have the same supply
rough-in, you may have to change the location of the
supply stop to install this toilet.
Closet flange must be 12” (30.5cm) on-center from
wall.
Electrical service requirements: dedicated 120
VAC, 15A, 60 Hz. (circuit protected by Class A
GFCI.)
E. ORDERING INFORMATION
Pillow Talk
Power Lite
Toilet
K-3379
. . . . . . . . . . . . . . .
When specified:
floor bolts (pr.)
21401
. . . . . . . . . . . . . . . . . . . . . . . . . .
3/8” supply
K-7638
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: For service parts ordering information, see
separate Service Parts document enclosed with product.
F. MATERIALS REQUIRED
3/8” shut-off valve
Closet flange
Toilet T-bolts (2) 5/16” diameter
Toilet gasket (wax seal)
G. TOOLS REQUIRED
10” (25.4cm) adjustable wrench
12” (30.5cm) pipe wrench
Tubing cutter
Level
Putty knife
Hacksaw/metal file (for shortening T-bolts)
Screwdriver
NOTE: Site preparation may require additional tools.
