GIULIANO Crossage, Инструкция по эксплуатации и обслуживанию

Страница: 27 / 50

27
Fig. 21
- Take the tool right out by operating the control lever H
Fig. 19
To avoid damaging the valve and/or the pressure sensor, move the
same to the “1 o’clock” position before inserting the tool in the
channel, operating the control lever H.
15.0_DEMOUNTING RUN-FLAT (Self-supporting) and UHP (Low profile) TYRES with
WdK kit
- Proceed as follows to demount the tyre:
- Turn the spindle to move the valve to the “1 o’clock” position (roughly 10 cm after the tool).
- Position the assembly head over the rim and block it using control button K (ref. 1 fig. 10a/b); this will block the
operating arm and the horizontal arm; the assembly head positions itself automatically at the correct distance from
the rim.
-Press the button in position 2; the arms unlock and the assembly head lowers onto the rim or down to the minimum
service height.
-Press the button in position 3; the arms unlock and the assembly head raises out of the work position
– Press the button in position 1 and the operating arm and the horizontal arm lock. The assembly head positions
itself automatically at the correct distance from the rim.
Fig. 10b
Fig. 10a