GIULIANO Crossage, Инструкция по эксплуатации и обслуживанию

Страница: 17 / 50

17
- Press pedal M and the wheel positioner P should raise; to lower the wheel
positioner, lift the same pedal upwards.
- Press pedal L on L2 and the spindle flange R should turn clockwise.
Press the pedal L on L1 and the spindle flange R should turn anti-clockwise.
NB: If the flange should turn in the opposite direction to that indicated, you need to invert two wires on the plug, if it
is three-phase.
- Turn selector A to the right to block the movement of the bead breaking carriage; in this situation, the carriage will
only move in work mode (over stroke) by pressing button G , at the back of the control panel.
If the selector is turned to the left (unblocked), the only movement possible will be that of approaching the bead bre -
aking carriage (right - left) using buttons C and D .
- Press button E and the bead breaking carriage will move upwards; press button F and the carriage will lower.
- Press button B and turn the bead breaking carriage Q , the latter will move out from the work position. Release the
button and the hook will block again. To move the carriage to the work position, turn the latter towards the machine
and make sure the hook blocks it.
- To turn the bead breaking disc, move handle U towards handle T and simultaneously accompany the disc support
by hand downwards or upwards.
- With the pedal I right down, the vertical arm V moves to the work position; with pedal I raised, the arm V tilts back -
wards out of the work position.
- Press pedal N to start inflating the tyre; if you wish to deflate the tyre, use button H at the side of the gauge.
10.0_OPERATIONAL TEST
All the procedures are to be performed without using a tyre, making sure
that no other parts of the machine interfere with the movements when per-
forming them.
A
C
E
F
D
B
G
H
R
P
Q
S
S
T U
V
L
I
M
N
L1
L2