Girard Systems G-Link G-1500, Руководство владельца по эксплуатации, настройке, ремонту и установке

Страница: 9 / 65

9
Girard Systems
©
2005
CARE
C. Instructions for CARE AND CLEANING OF FABRIC
To ensure longevity of fabric quality it is highly advisable to maintain a regular regiment of simply brushing
off daily debris and dirt from fabric. To clean the awning rinse with water. In a separate bucket mix a mild
soap in water (natural soaps are best) with a clean brush dunk into the bucket and clean the awning with
sweeping motions; rinse thoroughly to remove soap. If you decide to use a liquid detergent you will need to
reaply a water repellent treatment, such as 303 Hi-Tech Fabric Guard or similar product. Fabric is made
from 100% acrylic fiber. (If Fabric is non-acrylic-Soltis material use liquid detergent and water) Let
fabric air dry. If you need to store your fabric, keep in a dry ventilated area.
DO NOT SUBJECT AWNING FABRIC TO EXCESSIVE HEAT as the fabric will shrink.
DO NOT STEAM PRESS OR DRY IN ELECTRIC OR GAS DRYERS, but allow to air dry.
STAIN SOLUTIONS FOR:
Fruit Stain-liquid detergent/ammonia 3-6% water
Grease(car)-volatile solvent(acetone)
Iron Rust-oxalic or citric acids, water
Mildew-1/2 cup of bleach and 1/4 cup of natural soap per gallon of water
Oil-solvent (acetone)
Paint (latex) wet-liquid detergent, water
Paint (latex) dry-Paint, oil or grease remover
Paint (oil or laquer)-paint,oil grease remover
Tree sap-turpentine, liquid detergent
Repair and replace
D. RTS Remote Switch Battery Replacement
1) Remove RTS Remote Switch following the reverse of the installation.
2) Hold RTS Remote Switch by the front allowing easy access to the rear.
3) Using small phillips screwdriver remove the two screws from the recessed cavities in either corner.
4) Carefully remove back plate by lifting directly away from front plate (See Figure 3).
5) Use standard screwdriver or similar tool to slide old battery from cradle.
6) Insert new battery with fingers, and attach back plate using reverse of the removal.
7) Reinstall RTS Remote Switch and recalibrate if needed.