8
SETUP AND PROGRAMMING
1.
Change motor direction
a.
Supply power to
GC274B
b.
Simultaneously press the
LEFT
and
RIGHT
buttons of the
GC274B
for at least
6 seconds. The Green LED will illuminate and then blink a few times. When the
Green LED extinguishes, the operation is complete.
Fig.3
Note; when carrying out this part of the procedure each step must be
executed within 10 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
2.
Programming the GC274B to a Remote handset or Wall switch
a.
Supply power to the GC274B
b.
Press and hold the
MIDDLE
and
RIGHT
buttons on the GC274 (Fig 3) for
about 3 seconds until the Green LED starts to flash.
c.
Press STOP (Fig. 1): The Green LED will stop blinking and remain illuminated.
d.
Press the
IN
button on the REMOTE DEVICE being programmed. The Green
LED on the motor controller will extinguish.
CHANGE MOTOR DIRECTION
PROGRAM MODE
Содержание 98GC274B
Страница 7: ...7 ...
