21
d.
Press and hold the
MIDDLE
and
RIGHT
buttons on the GC274 (Fig 1) for about
3 seconds until the Green LED starts to flash.
e.
Press the Stop button on the Motor controller (see fig.3). The green LED will
illuminate continuously.
f.
Press the programming button on the GC779G Motion sensor (See Fig.14). Both
the Purple LED on the Motion sensor and the green LED on the Motor controller
will flash once and extinguish. This completes the programming sequence.
g.
Ensure that the code was accepted by pressing the Program button on the
GC779G Motion sensor again. The Awning should retract.
h.
If the Awning does not retract, repeat steps a. to f.
i.
Set the Adjustment Dial to the desired sensitivity level 1 to 5.
Never set higher
than 5.
(The factory setting is 3).
Once programming is complete, reassemble the motion sensor module and
mount on the awning lead rail.
For queries or assistance with programming any of your G-Link devices
please call Girard Systems TOLL FREE on 800
–
382
–
8442 between 7:30am
and 3:30pm P.S.T.
Содержание 98GC274B
Страница 7: ...7 ...
