20
d.
Turn the base plate over (Magnet down). Then place the motion sensor on top of
it so that the magnet is aligned with the reed switch. See fig.14.
If this is not
done the default program cannot be changed.
Fig.14
Note; when carrying out this part of the procedure each step must be
executed within 10 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
a.
Set the Motion sensor Adjustment Dial to level 5. (See Fig.14)
b.
To initiate the programming sequence, power to the motor controller must be
disconnected for at least 10 seconds then reconnected.
c.
Connect the GC779G Motion sensor to a 12volt DC circuit. At this point the
Purple LED will illuminate and then begin to blink. If it does not, the module is
not receiving the correct power. Ensure that the magnet and reed switch are
aligned and verify the electrical connection before proceeding.
Reed Switch
LED
Sensitivity Dial
Program Button
Содержание 98GC274B
Страница 7: ...7 ...
