System 3000
Electronic switching insert
(5)
Push-button, NO contact
Connect 600 W LED lamps or compact fluorescent lamps at most per 16 A circuit
breaker. When connecting transformers, observe the data of the transformer manufac-
turer.
The connected load on LED lamps is dependent on the type of lamp and installation con-
ditions. The connected load of the specified values could vary. We cannot assume any
guarantee for proper function.
Operation with neutral conductor
When switched-off, switchable LED lamps can be dimly lit or flash repeatedly. Use dimmable
LED lamps.
Operation without neutral conductor
Compared with operation with neutral conductor, the maximum brightness can be reduced de-
pending on the type of lamp.
There could be an increased likelihood of unsuitable combinations of LED lamp and switch in-
sert.
Lit push-buttons must have a separate N terminal.
Figure 2: Clampable conductor cross-section
The load can be switched by briefly pressing the Test button.
Reset the overheating protection / short-circuit protection
If the electronic overheating or short-circuit protection has been activated, separate the switch
insert from the grid for a few minutes.
4.2 Commissioning
Operation with neutral conductor
The device is powered via the phase conductor and neutral conductor. There is no leading edge
phase control or trailing edge phase control. Setting an operation mode is not necessary. There-
fore, button Test (1) and LED (2) have no function for commissioning.
Operation without neutral conductor
For operation without neutral conductor, the device is powered via the phase conductor and the
connected load. Therefore, the device operates in leading edge phase control or trailing edge
phase control. Generally, the device automatically sets the suitable operation mode. It may,
however, be necessary to set the operation mode manually.
Universal, R,L,C,LED
–
Preset at the factory.
Automatic calibration to the load, dimming principle, trailing edge phase control, leading
edge phase control or LED leading edge phase control.
–
Incandescent lamps, HV halogen lamps, dimmable HV-LED or compact fluorescent
lamps, dimmable electronic or inductive transformers for halogen or LED lamps.
LED trailing edge phase control,
{
The connection of inductive transformers is not permitted.
3 / 7
82400512
24.05.2019
