gio Vyper 4WD 1100cc 4 seater XY1100UEL, Руководство по обслуживанию

Страница: 49 / 261

3. CHECKS & ADJUSTMENT
3-6
Shift Linkage Inspection / Adjustment
Linkage rod adjustment is necessary when symptoms include:
• No All Wheel Drive light
• Noise on deceleration
• Inability to engage a gear
• Excessive gear clash (noise)
• Shift selectors moving out of desired range
NOTE: Remove necessary components to gain
access to shift linkage cable ends.
1. Inspect shift linkage cable, clevis pins, and pivot bushings
and replace if worn or damaged.
2. Be sure idle speed is adjusted properly.
3. Place gear selector in neutral. Make sure the transmission
bell crank is engaged in the neutral position detents.
4. With two wrenches loosen the outside jam nut
counterclockwise. Turn the outside jam nut 1 1/2 turns.
Perform this procedure on the shift lever end, also.
5. After turning the outside jam nut 1 1/2 turns. Hold the
outside jam nut with a wrench and tighten the inside jam
nut clockwise, until it is tight against the bracket.
6. Repeat Step 4 and Step 5 until the proper adjustment is
made for the transmission cable.
7. Use this procedure to loosen or tighten the shift linkage
cable as needed.
Fuel system and air intake
Fuel Lines
1. Check fuel lines for signs of wear, deterioration, damage
or leakage. Replace if necessary.
2. Be sure fuel lines are routed properly and secured with
cable ties.
CAUTION:
Make sure lines are not kinked or
pinched.
3. Replace all fuel lines every two years.
3