gio Vyper 4WD 1100cc 4 seater XY1100UEL, Руководство по обслуживанию

Страница: 252 / 261

12. LIGHTING AND SWITCHES
12-1
Overhaul Info……………………12-1 Horn…………………………………… 12-8
Troubleshooting…………………12-2
Replacing bulbs…………………12-3
headlight…………………………12-5
Ignition Switch…………………..12-5
Combined switch………………..12-6
Brake Light Switch……………….12-8
Overhaul Information
Warning
●
Headlight bulb will be very hot when it is turned on. Do not touch it after it is just turned off.
Operation should be done when the bulb is cooled down.
●
Inspection of water temperature alarm may use fire source and liquid of high temperature. Do
not put flammable matters nearby and take care not to get burnt.
●
The temperature of headlight is quite high when turned on. Replacing with bare hand or stained
glove will cause oil stains on the glass face which may form hot spot and cause deformation of
glass face and damage to bulb.
●
Pay attention to the following when replacing the bulb.
—Do not replace the bulb when it is turned on. Keep ignition switch in the OFF position, and
replace after the bulb is cooled down.
—Replace the bulb with hands in clean gloves to avoid oil stains on the glass surface.
—Clean the glass with a clean rag dipped in alcohol or isoamyl acetate in case of any oil stains
on the glass surface.
●
If the Inspection has to be done with battery, check if the battery is normal.
●
Inspection of switch continuity can be done without removing the switches from the vehicle.
●
After the inspecting and overhauling of each part, cables and wires should be routed properly
(chapter 1) Refer to Chapter 2 for removal and installation of taillight and rear turning lights.
Overhaul Standard
Item Standard
Mail switch fuse 30A
Fuse
Sub-fuse 10A 20A 30A
Head lamp
12 V 55 W× 2
Front position lamp
12 V 5 W
Headlight
Front direction indicator
12 V 1.6 W (15*LED)
Stop lamp
12 V 1.8 W (12*LED)
Rear position lamp
12 V 0.2 W (12*LED)
Light, bulb
Brake light
/Tail light
Rear direction indicator
12 V 2 W (15*LED)