gio Vyper 4WD 1100cc 4 seater XY1100UEL, Руководство по обслуживанию

Страница: 19 / 261

1. SERVICE INFORMATION
1-17
Compression Gauge
A compression gauge
(Figure 33
) measures combustion chamber (cylinder) pressure, usually in
PSI or kg/ cm2 . The gauge adapter is either inserted or screwed into the spark plug hole to obtain
the
reading. Disable the engine so it does not start and
hold the throttle in the wide-open position when
performing a compression test An engine that does
not have adequate compression cannot be properly
tuned. Refer to Chapter Three.
Multimeter
A multimeter
(Figure 34)
is an essential tool for
electrical system diagnosis. The voltage function
indicates the voltage applied or available to various electrical components. The ohmmeter function
tests circuits for continuity, or lack of continuity, and measures the resistance of a circuit.
Some manufacturer’s specifications for electrical components are based on results using a specific
test meter. Results may vary if using a meter not recommended by the manufacturer. Such
requirements are noted when applicable.
Ohmmeter (analog) calibration
Each time an analog ohmmeter is used or if the scale is changed, the ohmmeter must be
calibrated.
Digital ohmmeters do not require calibration.
1. Make sure the meter battery is in good condition.
2. Make sure the meter probes are in good condition.
3. Touch the two probes together and observe the needle location on the ohms scale. The needle
must Align with the 0 mark to obtain accurate measurements.
4. If necessary, rotate the meter ohms adjust knob until the needle and 0 mark align.
1