User Manual for Vital Signs Monitor
56
11.5 Instructions for SpO
2
Probe
Instructions for Neonate SpO
2
Y-type Sensor
Intended Use
When used with a compatible patient monitor or a pulse oximeter device, this sensor is intended to be
used for continuous, non-invasive functional arterial oxygen saturation (SpO
2
) and pulse rate monitoring
for neonates (1-3 kg).
Contraindications
This sensor is contraindicated for use on active patients or for prolonged use.
Instructions for Use
1)
Insert the two sensor tips into the slots on the rubber wrap
(A)
; place the sensor on the
neonate’s
foot
(B)
,
wrap the rubber belt around the foot and tighten accordingly
(C)
.
2)
Plug the sensor into the oximeter and verify proper operation as described in the oximeter operator’s
manual.
3)
Inspect the monitoring site every 4 hours for skin integrity.
Cleaning & Disinfection
Unplug the sensor before cleaning or disinfecting. Surface-clean sensor and cable with a soft gauze pad
by saturating it with a solution such as 70% isopropyl alcohol. If low-level disinfection is required, use a
1:10 bleach solution.
Warnings
1)
Some factors may affect the accuracy of saturation measurements. Such factors include: excessive
2)
patient motion, fingernail polish, use of intravascular dyes, excessive light, poorly perfused finger,
extreme finger sizes or improper placement of the sensor.
3)
The sensor must be checked for skin integrity at least every 4 hours. Because individual skin
condition affects the ability of the skin to tolerate sensor placement, it may be necessary to change
the sensor site.
4)
Do not use NIBP or other constructing instruments on same appendage as sensor for blood flow
interrupted by NIBP cuff or circulatory patient condition will result in no pulse found or loss of
pulse.
5)
Do not use the sensor during MRI scanning. Carefully route cables to reduce the possibility of
patient entanglement or strangulation.
6)
Do not alter or modify the sensor. Alterations or modifications may affect performance or accuracy.
7)
Do not use the sensor if the sensor or the sensor cable appears damaged.
Caution: Do not sterilize by irradiation steam, or ethylene oxide.
