GILES GBF-2-GVH Series, Руководство по эксплуатации и обслуживанию

Страница: 88 / 140

76
Operation GBF-2-GVH Ventless Fryer
8. On the unit being filtered , set the Oil Return Valve Handle
⑥
to the [FILL POT] position (horizontal) . The Oil Return
Valve on the other unit
⑦
must be in the [CLOSE] position
(vertical).
9. When oil has completely drained into the Filter Pan, set the
Pump Switch
⑧
to the [PUMP] position. Pump Switch is
located on the right side unit Control Panel; left side panel
has the switch location plugged .
10. Oil will begin to circulate through the filter media in the Pan
and return to the vat. Leave the Drain Valve open to allow
oil to continually recirculate through the system for approx.
5 minutes. During this time, use the provided Pot Brush and
L-Bend Brush to scrub and dislodge cooking residue and
crumbs from vat sides and heating elements, allowing it to
be flushed into the Filter Pan.
11. After approx. 5 minutes, return the Drain Valve Handle
⑨
to the [CLOSE] position. Allow vat to fill with reconditioned
oil. When pump discharge begins “blowing air”, refill is
complete.
7. Confirm that Heat Switch of the Fryer unit being filtered
remains in the [OFF] position. Inside the right-side cabinet,
be sure the Pump Diverter Valve
④
is in the [OIL RETURN]
position (horizontal).
ONLY on the unit being filtered , slowly rotate Drain Valve
Handle
⑤
to the [OPEN] position (right to stop). Drain
Handle of the other unit must remain in the [CLOSE]
position
. Used cooking oil should begin draining into the
Filter Pan.
5
4
NOTE:
If the oil does not readily drain, use the provided Kettle
Drain Brush to break up any crumbs or residue that might be
blocking or clogging the vat drain opening.
6
9
8
NOTE:
When filtering Fryers, Power Switch on right
side Panel must remain [ON] to run the Filter
Pump.
5.04 Filtering Used Cooking Oil - continued
• Never remove the Filter Pan from unit while it contains HOT cooking oil.
• NEVER drain oil from more than one (1) Fryer unit into the Filter Pan! It only has capacity to hold oil from one
(1) cook vat; anymore could cause an overflow of HOT oil.
During the next steps cooking oil is drained from the vat, exposing the heating elements.
Even though safety interlocks are in place, failure to place the Heat Switch in the [OFF]
position before draining could result in fire. ALWAYS CONFIRM THAT THE HEAT SWITCH IS IN THE [OFF]
POSITION BEFORE DRAINING THE COOK VAT.
7
Continued on Next Page