GILBARCO VEEDER-ROOT M00016K003, Руководство по установке

Страница: 19 / 30

MDE-4133B Power Supply Kit M00016K003 Installation Manual • November 2003 Page 19
Installation
10 Reconnect the Pump Control Node cable to the 10-pin connector P1301 on the STP board
(
Figure 5 ).
11 Use the supplied 3-pin to black wire adapter to pick off AC power from J550 on the AC
harness (
Figure 11 ) to go to the STP feed connector ( Figure 5 ).
12 Look for two 4-pin connectors (J604 and J1206) from the power supply ( Figure 9 ). Use the
supplied 4-pin to 3-pin adapter cable (M02952A001) to connect J604 on the power supply to
P1206 on the M00059A00X valve board (
Figure 7 ).
13 If the dispenser has a monochrome display with a flourescent backlight, locate a three
connector adapter with two red wires. Look at it carefully. One connector has two wires going
to positions 1 and 2; on the other two, two wires go to positions 1 and 3.
14
Plug the connector that has wires going to positions 1 and 2 into the AC adapter cable harness
(
Figure 11 ).
15 Plug the monochrome backlight cables (M03111A001 and M00614A004) into the other two
positions.
16
If the dispenser has a TRIND device, plug the TRIND device into the AC adapter cable
harness (
Figure 11 ).
17 If the dispenser has VaporVac device, use cable assembly M01665A001 ( Figure 13 ) to connect
the VaporVac device to J404 on the power supply AC adapter cable harness ( Figure 11 ) and to
P404 on the M02710A001 VaporVac power cable ( Figure 14 ).
Figure 13: Cable Assembly M01665A001
Figure 14: Cable Assembly M02710A001
P404A
J404A
Cable tie, push mount
Cable tie
P404
Ring
terminal
Cable tie, push mount
F6-1
FL1-3