GILBARCO VEEDER-ROOT FlexPay IV, Инструкции по обновлению

Страница: 10 / 26

MDE-5491A
6
SECTION 3 - REMOVING COMPONENTS
3
Replacing the E-CIM or Full Bezel
Depending on the upgrade, you might need to replace the full bezel or the E-CIM insert only.
• If the upgrade includes the printer option, then all components from the old bezel must be uninstalled
and re-installed on the new bezel. Refer to “Removing Components from Full Bezel” on page 10 .
• If the upgrade includes E-CIM only and does not affect the bezel, then remove all of the E-CIM
components and transfer to the new E-CIM insert. A new bezel is not required. Continue to the

“Removing Components from E-CIM” section.
Removing Components from E-CIM
To remove the E-CIM from the door:
1
Remove all cable connections from the electronics on the E-CIM door (see Figure 2 ). The following are
the cable connections:
• M14340 Power Cable from Peripheral Interface PCB (PIP)3, UPM, and card reader
• M14339 Serial Cable from PIP3
• M14338A001 and M14425A001 Applause™ Media System cables (if present) from UPM and PIP3
• Speaker or intercom cable (if present) from PIP3
• USB cable to printer from PIP3 (and second scanner, if present)
• Ethernet® cables from UPM and card reader
• M13119 Cable from door node
• Ground cables from UPM and card reader