Gigabyte GA-7DX+, Руководство пользователя

Страница: 90 / 143

BIOS Setup
80
••••
AGP Mode
4X Set AGP Mode to 4X (Only if the AGP Card support 4X Rate).
(Default Value)
1X/2X Set AGP Mode to 1X/2X.
••••
AGP Always Compensate
Enabled Enable AGP Always Compensate function.
Disabled Disable this function. (Default Value)
••••
SDRAM ECC Setting
Disabled Disable DRAM ECC Setting function. (Default Value)
Check Only
Set DRAM ECC Setting to Check Only. Enable DRAM error
checking function.
Correct Error
Set DRAM ECC Setting to Correct Errors. Enable DRAM 1 bit
error checking and correcting in CPU/AGP/PCI.
C Scrub
Set DRAM ECC Setting to Scrub. Enable DRAM 1bit error
checking and correcting in CPU/AGP/PCI and DRAM.
••••
DRAM Timing setting by
Auto Set DRAM Timing setting to Auto. (Default value)
Manual Set DRAM Timing setting to Manual.
••••
DRAM PH Limit
This function specify the number of consecutive Page-Hit requests to allow before
choosing a non-Page-Hit request.
1 Cycle Set DRAM PH Limit to 1 Cycle.
4 Cycle Set DRAM PH Limit to 4 Cycle.
8 Cycle Set DRAM PH Limit to 8 Cycle.
16 Cycle Set DRAM PH Limit to 16 Cycle.
••••
DRAM Idle Limit
This function specify the number of idle cycles to wait before precharging an idle bank.(Idle
cycles are defined as cycles where no valid request is asserted to the MCT.)
0 Cycle Set DRAM Idle Limit to 0 Cycle.
8 Cycle Set DRAM Idle Limit to 8 Cycle.
12 Cycle Set DRAM Idle Limit to 12 Cycle.