16
17
CAPTIVE
CAPTIVE
7 - CHANGING SIZE OF THE SAFETY EDGE
7.1 - REMOVING SAFETY EDGE
7.3 - SAFETY EDGE INSTALLATION
7.2 - CHANGING SIZES
Insert the supplied locking pin to uspend the movement
of the cam (a)
Withdraw the rubber
from the aluminium bar
Remove the upper
support from the
aluminium profile
Remove the cable
from the joint
to the lower support
of the edge
ATTENTION:
do not loosen the
locking screw that
locks the cable
from the cam
Unscrew the locking screw (b)
that locks the cable coming out
from the lower part of the edge
Slide the rubber in the aluminium profile(g)
When you have finished, the
rubber edge should over-
hang over 20mm compared
to the aluminium profile (i)
Keeping tension on the steel cable,
clamp the locking screw in this joint (l)
Remove the
locking pin (m)
Proceed to the “Cable tension and calibration” according to point 3.2.1
Proceed to the “Positioning of the cap” according to point 3.2.2
Push the cable into
the joint (k) taking it
through the oblique
hole
Reassembe the steel
cable through the
cable conduit housed
in the rubber edge (j)
Reassemble the upper support
in the aluminium profile (h)
1
2
3
EN
EN
EXAMPLE to get an edge of:
MBS = 1800 mm
Extruded rubber:
MBS mm -245 mm (cut) = 1555 mm
Aluminium profile:
MBS mm -285 mm (cut) = 1515 mm
