GHOST EPAC E-HYBRIDE Andasol 4 Man / Lady, Оригинальная инструкция по эксплуатации

Страница: 167 / 180

EN
Original operating instructions 11/2014
165
GHOST EPAC
E-HYBRIDE ANDASOL & ANDASOL X
E-HYBRIDE TERU & TERU FS
Check the rim for damage (sharp edges, chippings etc).
If you find such damage, please contact
your specialist bicycle dealer.
Check whether there are one or two small holes next to each other.
NOTE:
Two small holes indicate a puncture (snakebite).
This is a frequent cause when riding over sharp-edged obstacles
with too little air pressure.
If the rim is not damaged: Install a new inner tube.
9. If the leak is on the outside:
Hold the inner tube next to the rim with a tyre, as it was mounted.
Check the area of the tyre where the hole is located in the inner tube.
Often there is a thorn, a small stone or glass splinter in the tyre.

CAUTION Danger of cuts
If you feel the inside of the tyre with your thumb or finger,
you might cut yourself on sharp-edged objects
if these are still in the tyre.
- Avoid moving your thumb and fingers quickly along
the inside walls of the tyre.
- You should feel the walls of the tyre with extreme caution.
10. Remove the item causing the problem carefully with your fingernail,
penknife or similar item. If the tyre has been damaged or cut over a large
area, it also has to be renewed.
If a tyre change is needed:
1. Remove the old tyre completely from the rim.
2. Mount the new tyre with one side on the rim. Make sure that the arrow
indicating the direction of movement on the tyre is pointing in the direction
of rotation when the EPAC is ridden.
If no tyre change is needed:
1. Pump up the new inner tube somewhat,
so that it takes on its final shape.
2. Insert the valve through the valve hole in the rim. The valve must be
pointing towards the middle of the wheel.
3. Now press the side of the tyre which is still outside the rim into the tube
protector at the level of the valve.
4. Press the external sides of the tyre into the tube protector at the same time
around the circumference. Start at the valve.
5. Opposite the valve the force required to press the tyre in may be greater.
Use the tyre irons for this. Make sure that you do not damage
the inner tube.