Bedienungsanleitung
As of 04/20/2010
Seite 7/16
3
Assign the Expansion Box to the ProfiLux
3.1
Requirements
Before the
Expansion Box
can be assigned to the ProfiLux, all hardware modules have to build in.
Furthermore it is important that the select switch for the conductance is in the right position for the used
sensor type and the
Expansion Box
is powered up.
3.2
Assign the Expansion Box
If all PAB connections have been made and power supplied to all devices at the PAB, the Expansion Box
can be assigned. Therefore select menu item
Assign devices
in ProfiLux system menu
Config
PAB
. The ProfiLux scans all devices connected at the PAB and afterwards the serial numbers of the found
devices are displayed. Then select
all
the serials you want to assign to this ProfiLux and accept with the
Return
-key.
Further information can be found at
Description PAB
.
After this the resources (sensors and interfaces) of the
Expansion Box
are available.
3.3
The resources (sensors and interfaces) of the Expansion Box
After assigning, the resources are ordered in the ProfiLux in the following manner:
The numbering starts in every case with the internal resources of the ProfiLux, followed by the resources
of the module cards installed in the slots of the ProfiLux. The numbering of the resources of the module
cards depends on the order in the slots.
Then the resources of the first found and assigned PAB device follows, afterwards those of the second PAB
device, and so on.
The resources in an expansion box are numbered just as those at the ProfiLux. First the internal resources
of the
Expansion Box
, then the resources of the module cards in the slots of the
Expansion Box
. The
numbering of the resources of the module cards depends on the order in the slots, too.
3.4
The sensors of the Expansion Box
When the
Expansion Box
has been assigned to the ProfiLux, then the additional sensors and interfaces are
available immediately.
The numbering starts with the internal sensors followed by the sensors on the module cards at the
ProfiLux. Then the internal sensors of the first
Expansion Box
found by the ProfiLux and the sensors on the
module cards in the slots of the
Expansion Box
. After then the sensors of the second
Expansion Box
, and so
on.
