GGP ITALY MP 24 Li, Руководство оператора

Страница: 25 / 32

EN - 11
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• purchase a second standard battery
to immediately replace the discharged
battery, without compromising
the continuity of operations;
7.2.2 Battery removal and recharging
1. Press the retainer tab on the
battery (Fig. 16.B) and remove it
from its housing (Fig. 16.A);
2. Fit the battery (Fig. 17.A) in the battery
charger housing (Fig. 17.B);
3. Connect the battery charger (Fig. 18)
to a power socket with the voltage
indicated on the rating plate.
4. Fully charge the battery according
to the instructions in the battery/
battery charger booklet.
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45 °C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 18.A) from the
housing in the battery charger (do not keep
recharging when recharging is completed);
2. Disconnect the battery charger
(Fig. 18.B) from the mains;
3. Fit the battery (Fig. 16.A in its
housing pressing down until you
hear it click firmly into position which
ensures the electrical contact;
7.3 TOPPING UP THE CHAIN OIL TANK
NOTE The following symbol is found
on the chain oil tank cap (FIg.19.A) :
Chain oil tank
IMPORTANT Only use chain saw
oil or adhesive oil for chain saws. Do
not use oil containing impurities so as
not to block the oil filter and to prevent
irreparable damage to the oil pump.
It is essential that you use good quality oil
to lubricate the cutting parts effectively.
Used or poor quality oil does not
guarantee good lubrication and reduces
the working life of the chain and bar.
IMPORTANT Never run the chain
without sufficient oil, this could damage
the saw and compromise safety.
Check the amount of oil in the pruner device
by checking the oil level indicator (Fig. 19.B).
If the oil level is low, top up as follows:
1. Unscrew and remove the cap
(Fig. 19.A) from the oil tank.
2. Pour oil in the tank and monitor the
level on the indicator (Fig. 19.B).
3. Make sure no impurities penetrate
the oil tank when filling.
4. Screw on the oil cap and tighten it.
7.4 CLEANING
7.4.1 Cleaning the machine and the motor
After every work session, clean the machine
thoroughly to remove all dust and debris.
• To reduce fire hazards, keep the machine
and, in particular, the motor free of
leaves, branches or excessive grease.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or handgrips.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
• To avoid overheating and damage to the
motor or the battery, always keep the
cooling air vents clean and free of debris.
7.4.2 Cleaning the chain
Remove any traces of sawdust or oil deposits
from the chain every time it is used.
If there is excessive dirt or resin build-up,
disassemble the chain and place it in a
container with a specific cleanser for a few
hours. Then rinse it with clean water and
treat it with a suitable anticorrosive spray,
before reassembling on the machine.