gfm GF-Primo Dolly, Инструкция по эксплуатации и правила безопасности

Страница: 35 / 92

34
9 Pairing the HCU and Electronic unit
9.1
Pairing via cable:
To operate the dolly in wireless mode the electronic and the HCU must be paired. This will be pre-set
by the factory when the dolly is first delivered. If however, the units are not matching because,
perhaps, a replacement HCU is used it is essential to pair both units to each other.
Pairing the units can be done in cable or wireless mode.
Attention:
The Dolly will only function when the HCU and electronic unit are paired. If either unit
is swapped or exchanged the units must be newly paired!
To pair the HCU and electronic proceed as follows:
Connect the HCU and electronic unit with the delivered HCU cable by inserting the
connectors on the HCU cable into the connectors on the HCU and electronic unit
Tip:
As a refere
nce use the alignment markings on the „Fischer“
Connectors to insert correctly
Activate the dolly by pressing the on/off button on the HCU
Cable connection
Cable connection Dolly -
HCU
Marking Fischer
Plug