4
Signet 9900 Conductivity Transmitter
Installation
Panel Cutout
92 x 92 mm
(+ 0.8, - 0 mm)
3.6 x 3.6 in.
(+0.031, -0 in.)
Panel Cutout
92 x 92 mm
(+ 0.8, - 0 mm)
3.6 x 3.6 in.
(+0.031, -0 in.)
Panel Cutout
92 x 92 mm
(+ 0.8, - 0 mm)
3.6 x 3.6 in.
(+0.031, -0 in.)
Panel Cutout
92 x 92 mm
(+ 0.8, - 0 mm)
3.6 x 3.6 in.
(+0.031, -0 in.)
minimum
clearance
25 mm
(1 in.)
panel
Quick-clip
gasket on
front side
of panel
terminal
blocks
mounting
bracket
DC Power
Loop V
oltage
3-9900.394
Cond/Res Module
Do not mount in direct sunlight.
System Start-up: Step 1
Prepare the transmitter installation location.
If the back of the transmitter is diffi cult to access when installed, wire the
removable terminal blocks fi rst, then complete the installation.
Next step: Wiring (Step 2).
Panel Mount Installation
Tools and Equipment Required
●
Fine-tooth
fi
le
●
¼ DIN punch or jigsaw suitable for cutting panel opening to within 1 mm (0.04 in)
tolerance.
●
¼ DIN punches are available and recommended for creating clean, precise
openings quickly and easily in most instrument panels.
●
If a punch is not available, a jigsaw or other cutting tool can be used.
An adhesive template is provided to help guide the cutting process.
De-burr and smooth the opening with a
fi
le.
1. The panel mount transmitter is designed for installation using a ¼ DIN punch.
Recommended clearance on all sides between instruments is 25 mm (1 in).
2. Place gasket on instrument, and install in panel.
3. Slide mounting bracket over back of instrument until bracket snaps into
latches on sides of instrument.
To remove:
1. Secure instrument temporarily with tape from front or grip from rear of
instrument.
DO NOT RELEASE.
2. Press bracket clips outward and remove.
Field Mount Installation
Field mounting requires a separate mounting kit. The 3-8050 Universal Mount Kit, the
3-8051 or 3-8052 Integral Mount Kits, and the 3-9900.396 Angle Adjustment Adapter Kit
enable the transmitter to be installed virtually anywhere. Detailed instructions for
fi
eld
installation options are included with the 3-8050, 3-8051 and 3-8052 adapter kits
(see Ordering Information section).
For Field Mount installations with a Cond/Res Module, the 3-9900.396 Angle Adjustment
Adapter is required along with a 3-8050 or 3-8052 adapter kit to allow for suf
fi
cient
clearance for the wiring.
Field Mount with
3-8050 Universal Mount Kit
and Angle Adjustment Adapter
Field Mount with
3-8051 Integral Mount Kit
and Angle Adjustment Adapter
