GEZE SecuLogic RWS TZ 300, Инструкции по установке и пусконаладке с электрической схемой

Страница: 11 / 44

SECULOGIC TZ300
11
Replacing the lock cylinder 3.4
The lock cylinder must fulfil the following requirements:
Profile half-cylinder, 40 mm (30/10)
à
Eight-way adjustable
à
When the plant is in operation, disable tamper switch.
X
To do this, turn key to left for ten seconds. Right LED lights up green. à
The left LED goes out. Tamper alarm function is disabled for two minutes.
Take housing off the wall bracket.
X
Unscrew key switch.
X
Release cap screw and remove the lock cylinder.
X
Fitting a safety cylinder, length 40/10 3.5
If using a safety cylinder with 50 mm (40/10), use the spacers between key switch and housing.
Fit the spacers before the carrier plate; this moves the complete fixture to the back by 10 mm.
The spacer set is not included as standard with the door control unit.
The set also contains four longer screws, which must be used instead of the existing screws.
Replace the lock cylinder.
X
Fit a new lock cylinder and secure with cap screw.
X
Reassemble the door control unit in reverse order to disassembly.
X
Test the unit’s function.
X