Getinge 86 SERIES, Техническое руководство

Страница: 76 / 228

<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Page 76 of 174
CALIBRATION
Conductivity meter
Check the output signal from conductivity meter
To check the output signal, proceed as follows.
1. Press
[
on the conductivity meter.
2. Enter code 22 with
Y
and
Z
.
3. Press [ . Setup 1 appears.
4. Choose Output med
Y
and
Z
.
5. Press
[
. Lin appears on the upper line and Sel. Type appears on the lower line.
6. Press [ .
7. Choose 4-20 mA with
Y
and
Z
.
8. Press
[
.
9. Set 0/4 mA = 0.000 µS/cm with
Y
and
Z
.
10. Press
[
.
11. Set 20 mA = 200 µS/cm with
Y
and
Z
.
12. Press
[
.
13. Press Y and Z at the same time to log out.
Setting the cell constant
To set the cell constant, proceed as follows:
1. Press
[
.
2. Enter code 22 with Y and Z .
3. Press
[
. Setup 1 appears.
4. Press
[
until the display shows Cellconst.
5. Set the relevant cell constant with Y and Z ; see the calibration certificate
6. Press
[
three times. The display shows Setup 1.
7. Press
Y
and
Z
at the same time to log out.