Getinge 86 SERIES, Техническое руководство

Страница: 22 / 228

<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Page 22 of 174
1.1
1.2
1.1.1
1.3
1.4
GETINGE PACS 300
VERSION 3.51 (0283)
P01 PROGRAM NAME
PARAM1 PARAM2
MACHINE NAME
PHASE NAME
CYCLE COUNTER
00000
SETTINGS
CHOOSE A PROGRAM
1.1.2.1
WASH DOS TEMP
035.0C
1.1.2.2
1.1.2.3
PARAMETER #02
PARAMETER #03
PARAMETER #03
PARAMETER #04
1.1.2.57
1.1.2.58
1.1.2.59
PARAMETER #56
PARAMETER #57
PARAMETER #57
PARAMETER #58
PARAMETER #58
PARAMETER #59
1.1.2
CHANGE PARAMETERS
Change parameters (1.1.2)
In main menu 1, press S to go to the SELECT PROGRAM menu. Then press
J to activate “CHANGE PARAMETERS”. To select a program, press S again.
Every cycle has a set of preset parameters. When a cycle has been chosen as
explained in the previous section, the parameters appear on the display. The
number of the parameter depends on how the cycle was configured when it was
created in the program.
The parameters that have an “A” indication in the bottom right corner are
adjustable. With a class A password, the value can be changed by pressing
S .
If there is a letter “I” at the same place, the parameters are only for information.
P parameters can only be changed with class A + H passwords.
ENTER PASSWORD *
* Operator password required
Main menu 2, Machine name (1.2)
Main menu 2 shows information about the machine and the current phase. The
information cannot be changed.
Machine information (1.2)
The top line shows name/ID of the disinfection program and the bottom line
shows the current phase.
GETINGE PACS 300
VERSION 3.51 (0283)
P01 PROGRAM NAME
PARAM1 PARAM2
MACHINE NAME
PHASE NAME
CYCLE COUNTER
00000
SETTINGS