Getinge 86 SERIES, Техническое руководство

Страница: 60 / 228

<Doc_TEC><Doc_502606900><Rel_B><Lang_GB>
Page 60 of 174
Troubleshooting
The table below describes the fault codes that may be generated and a possible action
for each fault code.
This may only be done by authorized personnel. The machine is connected to
the electricity supply and some components are live.
Fault
code Fault Comment
F00
Power failure
If the power failure lasts for more than 59 seconds, the process
is aborted. The fault code is generated when the power returns.
F01 The motor cutout has
tripped. The motor cutout (-F01) for the circulation pump has tripped.
Possible action:
a. Check that there is power on all phases from the circulation
pump.
b. Check that the motor cutout is correctly set (see electrical
diagram).
c. Check that the pump impeller rotates easily.
d. Check the direction of rotation (see installation instructions).
F02 Water filling too slow. The water level sensor (-B11) is not activated within two minutes
of the start of filling.
Possible action:
a. Check that the shutoff valves are open and that water is
reaching the machine.
b Check that the solenoid valves open and that their filters are
not clogged.
c. Check that the strainer in the machine is not blocked.
F03
Emptying time too long
Emptying takes longer than five minutes or the water level sensor
(-B11) is still activated when the emptying phase is complete.
Possible action:
a. Check that the waste pump (-M02) pumps out water.
b. Check that the pressure switch changes over.
c. Check that the solenoid valve closes (water does not leak in).
d. Check that the strainer in the machine is not blocked.
F04
Water leakage in the
dryer.
The switch to water level sensor (-B12) is open.
Possible action:
a. Check that the check valves to the drying connection close.
F05 Door fault, soiled side Door does not lock (-S02) within 10 seconds or opens while a
program is running.
Possible action:
a. Check whether the microswitch (-S02) for the “door locked”
limit position has been activated within 10 seconds on door
locking.
b. Check that the motor (-M10) and the switch (-S52) for door
locking are working.
F06 Door fault, soiled side The door does not open (-S01) within 10 seconds.
Possible action:
a. Check whether the microswitch (-S01) for the “door locked”
limit position has been activated within 10 seconds on door
locking.
b. Check that the motor (-M10) and the switch (-S51) for door
locking are working.