Gestetner C7006dw, Справочник принтера

Страница: 63 / 144

Printer Does Not Print
51
4
Is the Data In indicator
blinking or lit after start-
ing the print job?
If the Data In indicator stays off, data is not being sent to
the printer or the printer may be resetting the print job be-
cause there was a long delay in receiving the data from
the computer.
❖
If the printer is using "I/O Timeout"
Increase the value of the "I/O Timeout" setting of the
"IPDL-C Menu" or "RPS2 Menu". Or set the "I/O Tim-
eout" value to "0" (this is the off setting).
⇒
P.83 “Using
the Operation Panel”
❖
If the printer is connected to the computer using the
parallel cable
Confirm that the printer port settings are correct. For a
parallel port connection, port LPT1 or LPT2 should be
set.
For more information about the printer port settings,
see the notes after this table.
❖
Network connection
Contact your network administrator.
If the Data In indicator is blinking or lit.
The printer may be resetting the print job. Take the fol-
lowing steps to correct the situation.
• Increase the "Job Timeout" setting of the "IPDL-C
Menu" or "RPS2 Menu".
• Confirm that the printer driver settings are correct.
• Change the "Transfer" setting in the "System Menu".
• Confirm that the "Parallel" setting in "System Menu" is
correct.
Do you print via a net-
work? Confirm that the "Ethernet" setting is correct from the op-
eration panel.
⇒
P.88 “Menu Table”
The setting governs the data transfer speed used by the
Network Interface Board. Three options are available:
• Auto (default)
• 100 Mbps
• 10 Mbps
Note
❒
For details about the appropriate setting to use on
your network, contact your network administrator.
Possible cause Solutions