Gestetner A265, Руководство по обслуживанию

Страница: 690 / 855

SERVICE RAM ADDRESSES
A265/A267 4-86 SM
6800C9(H) - User parameter switch 09 (SWUSR_09)
Bits 0 to 7: Not used
6800CA(H) - User parameter switch 10 (SWUSR_0A)
Bit 0: Not used
Bit 1: 2 into 1 0: Off, 1: On
Bit 2: Not used
Bit 3: Page reduction 0: Off, 1: On
Bits 4 to 7: Not used
6800CB(H) - User parameter switch 11 (SWUSR_0B)
Bit 0: Not used
Bit 1: Method of transmitting numbers after the “Tone” mark over an ISDN line
0: UUI, 1: Tone
Bits 2 to 5: Not used
Bit 6: Printout of messages received while acting as a forwarding station
0: Off, 1: On
Bit 7: Polling Standby duration 0: Once, 1: No limit
6800CC(H) - User parameter switch 12 (SWUSR_0C)
Bits 0 to 7: Not used
6800CD(H) - User parameter switch 13 (SWUSR_0D)
(This switch is not printed on the user parameter list.)
Bits 0 and 1: PSTN-1 access method from behind a PABX
Bit 1 0
Setting
0 0 PSTN
0 1 Loop start
1 0 Ground start
1 1 Flash start
Bits 2 to 3: PSTN-2 access method from behind a PABX (only if an optional SG3
board is installed)
Bit 1 0 Setting
0 0 PSTN
0 1 Loop start
1 0 Ground start
1 1 Flash start
Bit 5: Action when receiving a SETUP signal containing no called number and the
G4 subscriber number was programmed in this machine.
0: Respond to the call, 1: Do not respond to the call
Bit 6: Action when the received HLC (Higher Level Capabilities) is Tel or BC
(Bearer Capabilities) is Speech.
0: Do not respond to the call, 1: Respond to the call
This switch determines which information transfer capabilities the machine can
accept when receiving a call.
1: When the received HLC is Tel (digital telephone) or BC is Speech (voice), the
machine responds to the call. In short, the machine receives every call.
This switch is useful for communication problems when the other terminal informs
the above transfer capabilities although it is a fax machine.
Bit 7: Not used
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA