German pool SAC-109, Руководство пользователя

Страница: 22 / 64

P.22
Indoors
Outdoors
Front panel
Wiring diagram
Terminal block
cover
5mm
Installation Instructions
Drilling a Hole in the Wall for the Piping
1. Decide where to drill the hole in the wall for the piping
(if necessary) according to the position of the mounting
plate;
2. Install a flexible flange through the hole in the wall to
keep the latter intact and clean.
Electrical Connections – Indoor Unit
1. Lift the front panel.
2. Take off the cover as indicated in the diagram (by removing
a screw or the hooks).
3. For the electrical connections, see the circuit diagram
on the right part of the unit under the front panel.
4. Connect the cable wires to the screw terminals by
following the numbering. Use wire size suitable to
the electric power input (see name plate on the
unit) and according to all current national safety
code requirements.
5. The cable connecting the outdoor and indoor units
must be suitable for outdoor use.
6. The plug must be accessible also after the appliance
has been installed so that it can be pulled out if necessary.
7. An efficient earth connection must be ensured.
8. If the power cable is damaged, it must be replaced
by an authorised Service Centre.
Note
The hole must slope downwards towards the exterior.
Keep the drain pipe down towards the direction of
the wall hole, otherwise leakage may occur.
Note
The cable wires have been connected to the main
PCB(without ferminal block) of indoor unit by the
manufacturer .