December 2014
Baby Fold Operator Manual
11
Problem Solving
N° SYMPTOM
CAUSE
SOLUTION
1
Folder does not switch on.
- Power source is off.
- Ensure that the power cable is connected
- Check the fuses on the folder power plug
2
Folder first panel damaged
- Paper lead edge curled and 1
st
panel 3- 5 mm
longer than other panels
- Perform the adjustment procedure of fold program
panel by removing 3-5 mm (1A= -3/-5mm).
3
The folder emits a sound when a copy is feed.
- The folder is still folding the previous copy
- The copy was not cover S3 introducing sensor
- Wait that the current folding process is over
- Check the folding program plot length too short if A4
or A size select P4
4
Copy package not correct
- Program P4 with steady or flash led require
exact plot length
- Copy fold package tolerance is ± 1mm
- 20 or 25mm margin tolerance is ± 3mm
- Example 3times 9=297mm or 8 times 105mm=840mm
5
The folder often jams
- Paper curled or more than 90 gsm weight
- Wrong Fan folding Program
- Use paper not curled and 75 – 80 – 90 gsm weight
- Do not select P3 flashing for fan folding
6
Folder at switch on, Motor runs immediately
- Sensor S0 is damaged or active
- Remove paper under sensor S0 , press reset and off and
on then folder. If problem persist open a service call .
7
The arrow key do not eject paper jammed
from folder
- All sensors are covered
- Remove paper from one of sensor and than do the
manual ejection
8
Folder beeps every 4 seconds and lit on red
led as orange led
- Folder have reached number of fold limit, trial
time or loan time expired
- Call service
9
Folder folds cross fold panel 297mm,11”,12”
instead of fan fold panel dimension
- Paper edge out of square or missed copy feed
- Sensor SO cover not at same time of sensor S1
10
Automatic Eject procedure failure
- Paper stuck between mobile roller and plate
- Pull out the paper from the folder entrance
