15
3.
Click “Save” button to save the settings.
4. Set the schedule of the fire detection. The setup steps of the schedule are the same as
the schedule recording setup. (See
4.2 Temperature Measurement
Temperature Measurement: When detecting the temperature of the pre-defined
point/line/area exceeds the temperature threshold value, alarms will be triggered.
Click Config
→
Temperature measurement to enter the following interface.
1.
Click “Enable” and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer
to
Fire Detection
chapter for details.
3. Set thermography rule.
Click the “Area” tab to go to the following interface.
The thermography rule type includes Point, Line Area.
Point setting
:
After the type is set to “Point”, click “Draw Area” and then drag the mouse in
the image on the left sid
e to move the point. Click the “Stop Draw” button to stop drawing. Up
to 10 points can be set in the above interface.
Line setting
: After t
he type is set to “Line”, click “Draw Area” and then drag the mouse in the
image on the left side to draw a line. Cli
ck the “Stop Draw” button to stop drawing. To ensure
the accuracy of temperature measurement, it is recommended to set not more than two lines
at the same time.