Geosignal XP 101K USB, Руководство пользователя

Страница: 10 / 24

• Replace the line “MEMORY: 32767” with “Memory:
ERASExxxxx” where xxxxx is the 5 digit code specific to your
data logger. For example if your code is 01234, type:
“Memory: ERASE01234”
• Please note: The command is case sensitive “ERASE” must
be in capital letters.
• Save the file to activate the code: the red LED of the data
logger will quickly flash for a few seconds and the data logger
will restart.
• CLOSE the file CONTROL.TXT and reopen it: Now, if the
code was correct, it will read: “Memory: 00000” indicating that
the memory is blank and the device ready.
Charging battery
•
Please note that the battery of the logger is charged while the
logger is connected to the USB port.
• Battery Life Expectancy: A battery with 50% charge would
allow the logger to record a full memory a few times.
•
Battery voltage is checked automatically by the data logger
when it is inserted into the USB socket. The charge
percentage is shown as “Bt 99%” in the file CONTROL.TXT
and it is worked out from the battery voltage which may not
reflect the real level of charge all the times, charge the logger
to 70% for a few hours, please take also in account that the
battery may have an internal self discharge.
• 99% (2.9V) is the maximum level of charge possible and it
depends on the battery brand and age normally a 70%
(2.75V) is acceptable. Batteries polarise and show less after a
few minutes charging has stopped, as the battery ages the
effect increases.
•
Procedure: Make sure the data logger is stopped and it is not
sampling in the next minutes, close the file CONTROL.TXT,
detach the data logger from the USB socket, reattach the data
logger to the USB socket, reopen the file CONTROL.TXT,
read the updated battery value.
• The charge level shown can vary between 0% and 99%
Geosignal XP 101K USB Data Logger
Copyright 2017-2018 all rights reserved
www.geosignal.com.au
10