George Foreman GFBL4000AU, Инструкции и гарантия

Страница: 7 / 28

7
CAUTION: Ensure the bottle does not unscrew from the blade assembly when
removing it from the motor unit. If loose, turn the Blastomatic bottle clockwise again
to tighten, and then turn anti-clockwise to remove the bottle and blade assembly
from the motor unit.
• Remove the Blastomatic blade assembly from the bottle by turning counter-clockwise.
• Replace the blade assembly with the Blastomatic drinking lid.
• Switch the blender off by pressing the ON/OFF button. Always switch off and
disconnect the appliance from the wall power outlet when not in use.
PREPARE THE PERSONAL BLENDING BOTTLE FOR USE
The personal blender bottle is perfect for single serve drinks, shakes and smoothies
NOTE: Prior to use, the bottle should be dismantled and washed as instructed in the
CARE AND CLEANING section on page 8 of this manual. Following cleaning:
• Place the bottle on a flat surface with the open end facing up.
CAUTION: Never blend dry goods alone in the bottle (always add liquid) and ensure
ingredients are at room temperature or below.
For best results, add ingredients in the following order:
a. Liquids
b. Ice
c. Hard Foods
d. Soft Foods
e. Powders
CAUTION: Handle the sharp blade assembly with care.
• Fasten the bottle blade assembly on to the open end of the bottle and turn it
clockwise until it is tight.
• Sit the motor unit on a stable, level, dry surface.
• Turn the bottle upside down and place on the blender base, turning clockwise to lock
into place.
CAUTION: Hold the bottle!
NOTE: Before starting the motor, place and leave your hand on top of the bottle to
prevent the possibility of it being dislodged by the sudden movement of ingredients
when the motor starts.
• Select the appropriate speed or use PULSE to blend to desired consistency. It is
recommended you only use speeds 1-3 or the ‘Auto 3’ Smoothie pre-programmed
function when using the bottle.
CAUTION: Wait until the blades come to a complete stop before proceeding any
further.
• Once blending has finished, remove the bottle by turning counter-clockwise and lifting
off the base. Turn the bottle over and place it on a flat surface with the blade assembly
end facing upwards.