George Foreman GFBL4000AU, Инструкции и гарантия

Страница: 10 / 28

10
CLEANING THE BLENDER JUG (THOROUGH CLEAN)
• Before cleaning, turn off and disconnect the appliance from the wall power outlet.
• Remove the jug from the motor unit.
CAUTION: Handle the jug with care when cleaning as the fixed blades are extremely
sharp.
• Wash the jug and all other removable parts in hot soapy water.
• Rinse well and allow all parts to dry before storing.
• Alternatively, the jug, lid and cap may be washed in the dishwasher.
IMPORTANT NOTE: DISHWASHERS: To preserve the appearance of the unit it is
recommended all removable parts are washed by hand. Alternatively, removable
parts may be placed in the dishwasher. Note some dishwashers have a heating
element sitting directly below the bottom rack - ensure items are never placed close
to or directly above the heating element.
• Place the jug upside-down on the bottom rack, ensuring it is not placed near any
heating elements. The lid and cap should be placed on the top-rack only.
CLEANING THE BLASTOMATIC AND PERSONAL BLENDING BOTTLE
• Before cleaning, turn off and disconnect the appliance from the wall power outlet.
CAUTION: Handle the sharp blade assembly with care.
• If assembled, unscrew and separate the blade assembly from the bottle.
• Wash the bottle, blade assembly and drinking lid by hand or alternatively place in the
dishwasher. Place the bottle on the bottom rack and all other parts on the top-rack
only.
IMPORTANT
• Do not place jug or bottle parts in boiling liquids or pour boiling liquids into the jug or
bottle.
• Do not immerse the motor unit in liquid. Wipe with a damp cloth and dry thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and non-abrasive cleaner.
NOTE: If liquids spill onto the motor unit, immediately switch off and disconnect from
the wall power outlet, wipe with a damp cloth and dry thoroughly. Do not use rough
scouring pads or cleansers on parts or finish.
TROUBLESHOOTING
Problem Possible Cause Solution
All LEDs blinking
quickly
(100 msec/time) Overheat warning or
button held longer
than 30 seconds Unit must be reset. Unplug to reset. Let unit cool for at least 20
minutes
Unit stops/goes into
standby mode Work time exceeds
150 seconds
(2.5 minutes) Re-select appropriate speed