10
English
CONNECTIONS
Power supply
The GEONAV can be powered by us-
ing the appropriate power supply
cable with car lighter plug or the
built-in battery pack.
Install the power supply cable with
the jack connector into the plug 1 as
shown in the figure, then exert a light
pressure until clicking.
When the cable is disconnected, make sure that the connec-
tor is protected by the appropriate rubber cap.
External power supply
The figure below shows the car lighter adapter.
The adapter has a little lamp (LED) that goes on if the car is
correctly providing power to the bracket. If the lamp is off:
•
check that the 12V voltage is available from the lighter
plug;
•
open the adapter and check the fuse.
If the fuse is interrupted, replace it with a fuse having the
same electrical characteristics (T2A).
NOTE: DO NOT USE ANY BYPASS CIRCUIT.
The fuse ensures that the special protection circuit inside the
plotter works properly in case of accidental short-circuit, po-
larity inversion and overvoltage.
Connections
Содержание 4 gipsy
