G406S User Guide Document: G406S-2
------------------------------------------------------------------------------------------------------------------------------------------------
19
Step 5: Individual monitor position adjustment based on Horizontal and Vertical Position Reference
resulting from Step 4.
TV1: increase [Overlap] value in Left Edge and decrease [Overlap] value in Right Edge to align
Vertical lines to match TV3
TV2: increase [Overlap] value in Top Edge and decrease [Overlap] value in Bottom Edge to align
Horizontal lines to match TV1
TV3: increase [Overlap] value in Bottom Edge and decrease [Overlap] value in Top Edge to align
Horizontal lines to match TV4
TV4: increase [Overlap] value in Right Edge and decrease [Overlap] value in Left Edge to align
Vertical lines to match TV2
Step 6: After final image positioning, all horizontal and vertical pattern can be matched together.
The setup procedure is finished.
Aspect Ratio and image distortion
If the source content aspect ratio is not 1:1 in this Video Wall setting, the final image will have
some distortion.
User can adjust source resolution and content aspect ratio to fix this issue
Set display EDID with 2160*2160 with same as the aspect ratio of Video Wall.
Use PC as signal source with 2160*2160 output resolution and apply content with 1:1
aspect ratio. Customized output resolution setting in PC may be required.
If source resolution and content doesn’t match the above conditions, user can adjust the
display aspect ratio in video wall settings to reduce image distortion but it may have below
issues:
With some blanking area at some borders.
1
st
alignment to set
Position Reference
(Set center lines)
2nd alignment to
finish all position
alignments