G406S User Guide Document: G406S-2
------------------------------------------------------------------------------------------------------------------------------------------------
7
3.3
If Loop out port has not been used, user can use loop out port to connect with monitoring system in
control room to see the status of the source signal.
4 Step 4 – System Connection and Power On
4.1
Poor quality HDMI cable and signal source will affect the connection distance and may cause signal
noise.
4.2
To ensure all cables are connected correctly, it is recommended to use locking cables.
4.3
Complete video wall system should be connected to one power Distribution Box with proper grounding.
To check whether floating voltage exists between HDMI cable and G406s housing. Power on the
system after finishing all connections to avoid system damage by floating voltage among devices.
4.4
When G406s power is switched on, the booting time is about 19 seconds and the Input & Output LEDs
on front panel will stay “Lighted” while G406s has correct input source and output monitor connections.
5 Step 5 - System setting: Box ID, RS232, Ethernet
5.1
The system setting for Box ID, RS232 and Ethernet can be set through CH-1 or CH-2. Please make
sure to connect monitor to the channel to see the OSD and execute system setting.
5.2
User can control G406s directly from Ethernet. The default static IP address is 192.168.0.100. User can
change the IP address for further operation.
5.3
When multiple units are used in the same environment, user can set different IP address or Box ID for
each unit so that user can execute independent control to each GeoBox without interference.
5.4
Box ID range is from #0 - #99. When user uses remote controller to control the system through OSD,
the maximum ID setting for remote controller is #0 - #9.
5.5
Remote Controller
User can control individual GeoBox through below method when all boxes or IR extender
receivers are installed together so that all units can receive the same IR signal.
To Press 851 number keys on remote controller will lock all other GeoBox OSD menu
except ID #1 GeoBox. User can see flashing LED on the Front Panel for the units with OSD
locked.
To Press 853 will only unlock ID # 3 GeoBox for further OSD operation.
Press 850 will unlock all GeoBox OSD menu. Remote controller can access to all GeoBox
simultaneously.
5.6
RS232 setting
Able to select RS232 baud rate between 9600 & 115200 for different controller system.
5.7
Ethernet
User can connect all GeoBox and PC in one Ethernet (or WiFi) Router (or switch hub) LAN ports
and set at DHCP or different Static IP address for each Box.
User can check IP address under [Ethernet] OSD menu. Then connect GeoBox through Chrome
or Explorer by IP address to open WebGui for further operation.