The control panel must be mounted on an interior wall that
is centrally located in the home.
Since the control panel at the same time functions as a
room thermostat, it is important to observe the following:
• Do not expose the control panel to direct sunlight
• Do not place the control panel on an outer wall
• Do not recess the control panel in the wall
• Do not place the control panel over a heat source
A lamp close to the control panel can affect the light
sensor so that the control panel will not regulate the light
intensity as intended.
On the front of the control panel in the ring there are 7
keys that are used to operate the panel. The function of
the keys changes depending on the menu selected.
(More information is available under Operation).
There is an infrared movement sensor located under the
glass screen. Simply by moving your hand past the control
panel you can bring up the menu for daily operating
options. (This function can be turned off:
See under Main menu/Display/Menu item 5).
The following are located at the bottom of the control
panel:
1: SD card
2: Room sensor
3: Light sensor
4: Mini USB port for connection to computer
1: The removable SD card contains all the control models
and versions that make the control panel compatible with
older versions. The SD card also contains all the langu-
ages, menus, help texts, symbols and collected data logs.
During the start-up procedure, the current versions are
installed in the control panel so that the control can
function without the SD card. However, the help texts will
not appear in the display and the data logs will not be
saved.
4: In order for a computer to read the data logs,
the Genvex data logger program must be installed.
3. INSTALLATION
Please see the installation guide.
The first time the system is started, the control panel
display will show: “Choose language”.
Click “Next” to switch between available languages. Press
“Enter” when the desired language is shown in the display.
The control panel will now load the current program
version in the selected language.
The display will show:
• Updating model (loading the current model)
• Wait 1.5 minutes (It takes approximately 1.5 minutes to
load the current version)
• Language load (91)
• Language OK
• Menu load (84)
• Menu OK
• Icon load (369)
• Menu OK
• Reset to default
• Restarting……..
• Optima 251 UK
The display will then change to:
• The Genvex logo
• Optima 251 UK
• Version number
D (Control panel): X.X
C (Main board): X.X
Finally, the display changes to daily operation and the
system is now in operation with the factory setting which
is only a basic setting.
The system is now ready to be adjusted with the most
optimal air flows and the operational desires and demands
for the dwelling in question, e.g. weekly operation,
temperatures etc. to achieve the most effective utilisation
and operation of the system.
2. CONTROL PANEL
4. START-UP
4
