Genvex GE ENERGY 1, Руководство по установке

Страница: 10 / 16

10
Installation
Optimum initial adjustment of plant
Air measuring equipment is used.
Before starting initial adjustment, check that the 6 points
in the inspection and initial adjustment section have been
carried out. Then start up the unit:
Maintenance of plant - Optima 250 DESIGN
Filters :
When the red lamp on the control panel flashes, the
filters must be changed/cleaned. Stop the unit with the
switch on the unit or the electrical panel. Open the front
cover and take out the filter. When the filter has been
changed or cleaned by shaking it and by removing the
worst dirt, switch on the unit and press the enter button
on the control panel for 10-15 seconds until the Genvex
logo starts flashing again and the equipment is back in
normal operation.
Careful handling of the plates is required.
They have sharp edges and must not be
damaged.
Do not vacuum or clean at high air pressure. It
will damage the filter!
Maintenance of plant - Optima 100
Please pay attension to the red diode wether it is flashing
or constant on. If it is constant on the filters must be
changed. If the diode flashes the filter in the exhaust
hood must be changed.
G4 = Standard filter
(Coarse filter class G4)
F5 = Fine filter (Fine filter class F5)
F7 = Pollen filter (Fine filter class F7)