6
5. After switching to the AUDIO system screen, touch the
buttons in the order of “1”, “5” and “ENTER” on the screen.
6.
After switching to the Vehicle and Navi Signal Check screen,
touch “ “on the screen to switch the display screen to
“NAVI GPS ANT”. Verify that “NAVI GPS ANT: OK” is
displayed.
If not OK, verify the connection condition again.
7. Press the POWER/VOLUME dial to switch to the AUDIO
screen.
8.
Switch the ignition off
Connection verification of +B/ACC connector and USB connector
1.
Turn the ignition switch to the ON position.
2. When the Audio off screen is displayed after the opening
screen ends, press the NAV button.
3. When the screen in the figure on the left is displayed, the
connection verification is completed. If it is not displayed,
verify the connection condition again.
4.
Switch the ignition off.
NAV button
Audio off screen
x
The procedure from this screen is performed by a user.
This procedure ends on this screen.
x
If the continue button is pressed, perform the “Reset
procedure” (Pg. 7).
