5
1. Connect the negative battery cable and perform an operation check by referring to the owner’s manual
applicable to the vehicle.
Tightening torque : 2.9 – 4.9 N
䌭
m
2. If there is any malfunction, disconnect the negative battery cable and verify that each connector is properly
connected and the wiring harnesses are not damaged or pinched, then perform the operation check again. If it
does not operate normally, contact the dealer where the unit was purchased.
䕔
After installing the car-navigation unit, verify the connections of the GPS antenna, +B/ACC, and USB
connectors using the following procedure:
Connection verification of GPS antenna connector
1.
㼀㼡㼞㼚㻌㼠㼔㼑㻌㼕㼓㼚㼕㼠㼕㼛㼚㻌㼟㼣㼕㼠㼏㼔㻌㼠㼛㻌㼠㼔㼑㻌㻻㻺㻌㼜㼛㼟㼕㼠㼕㼛㼚㻚
2. After the opening screen ends, the Audio off screen is
displayed.
3.
Press the POWER/VOLUME dial to switch to the on screen.
4.
Press the POWER/VOLUME dial and SEEK UP button at the
same time on the Audio on screen (press POWER/VOLUME
dial a little earlier).
5. OPERATION CHECK
㻭㼡㼐㼕㼛㻌㼛㼒㼒㻌㼟㼏㼞㼑㼑㼚
POWER/VOLUME dial
SEEK UP button
㻭㼡㼐㼕㼛㻌㼛㼚㻌㼟㼏㼞㼑㼑㼚
POWER/VOLUME dial
